What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
15.06.2025 02:16

At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
Here is a simplified AC power diagram.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Ms. Rachel Has Been In Touch With Olivia Munn, And Urges Fans To “Be Kind” To Her - BuzzFeed
At least they know the answer if they wanted it.
He then describes the function of a fuse.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
But… the neutral is now “floating” because of the 1 ohm resistance.
The other is “what does a “fuse” do?”
Edit 2024–10.
The bolt then partially travels down the line to your home.
First Sentence:
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
For this case there are devices called Metal oxide varistors (MOV).
nine
He then describes Rainy Season and Lightning.
Jean Smart Goes South and Solo in Call Me Izzy - Vulture
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
It seems Mohan does not understand the difference between a comment and an Answer.
A fuse is a non-resetable over current circuit protector.
Why do liberals think it is okay to steal votes while the rest of us obey the law(s)?
The MOV will conduct when the voltage exceeds 50% of line voltage.
eight
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
what exactly is a ‘surge’ protector?
It also is a device that limits the change in current flow.
Have you ever had your crush reject you, and then later you all dated and married?
This device then solves the entire problem.
So, the voltage could go up to 500 volts, and the fuse will not open up.
but I think this circuit , shows a few more pieces.
Why do many women wear sleeveless shirts, more so than men?
2024–10–10[John johnson John Johnson ]
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
What do you do when your family doesn’t care about you?
This one hit behind the barn.
These are simplified answers to the original question, and does not change anything I wrote above.
The third is lightning and “how it gets conducted into a home.”
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
There are three different concepts here that are getting confused.
[old diagram got deleted by accident]
He then asserts :
An AC voltage/ current source, and an ac inductive load.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
(Dc diagram shown, AC is similar).
Barnstars:
These devices are installed between the “hot” and “neutral” and protective ground.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
What is lightning?
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
the problem then depends on "how fast does the fuse operate?".
2024–10–16 [ OO OLAOYE OYEBODE ]
Now when you have a certain ac resistance, then a current flows in a loop.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
[image of Common-mode choke]
I post the exact comment here.
Because the load is inductive, the current lags the voltage.(by a bit).
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Upvotes:
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
But it can get overloaded, and no longer works.
One
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
A circuit breaker is similar, but is resettable.
In schematic diagrams this is the symbol for a fuse:
This is where this question deviates from being a 'generic' question, and becomes more specific.
This is where the MOV conducts again, and dissipated the energy.
2024–10–14 [Omar Gharbi Omar Gharbi ]
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Can the fuse protect the electronic devices from lightning instead of a surge protector.
a photo is worth a thousand words.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
One is “what exactly is in a ‘surge protector’ ? ”
so, what happens?
but this device (an Inductor) … impedes the rapid changes in the current.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
This is 'the assistant's answer'
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
What does a fuse do?
There are two important concepts here.
At one ohm, the resistor has a maximum of 1 watt power.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”